An energized electrical work permit is a written authorization, required by NFPA 70E, that justifies why live electrical work cannot be de-energized and documents the hazards, protective measures and approvals.

An energized electrical work permit (EEWP) is a document that must be completed and approved before qualified workers perform certain work on or near exposed live electrical parts. It explains why the equipment cannot be put into an electrically safe work condition, describes the shock and arc flash hazards and lists the protective measures that will be used.
The permit exists because the safest electrical work is de-energized work. It forces a deliberate decision, with management sign-off, before anyone accepts the risk of working live. Many energized work requests are withdrawn once people see what the permit requires.
Electrical shock and arc flash injuries are often fatal or life-changing, and many happen during work that could have been done de-energized. Production pressure can make working live feel normal. The permit process slows that decision down and puts the risk in front of the people who approve it.
A completed permit also documents that hazards were assessed, PPE was chosen correctly and the area was controlled. That record protects workers, supports compliance and helps organizations find recurring live work that could be designed out.
Under NFPA 70E, energized work is only justified when de-energizing would create a greater hazard, such as shutting off life support or ventilation in a hazardous location, or when it is infeasible because of equipment design or operational limits. Inconvenience or lost production alone is not a valid reason.
A plant manager asked electricians to replace a breaker in a live 480-volt panel to avoid stopping a production line. When the electrician started the permit, the justification section could only say the line could not stop. The safety manager rejected the permit because lost production is not a valid reason.
The job was moved to the weekend shutdown and done under lockout/tagout. The plant later added a second feed so similar work could be done without stopping production or working live.
Under NFPA 70E, when work is done within the restricted approach boundary or when a worker interacts with equipment where an arc flash hazard exists, unless an exemption such as testing or troubleshooting applies.
Yes. Testing, troubleshooting and voltage measuring by qualified persons are exempt from the permit, but workers must still use the required PPE and safe practices.
The permit is approved by the responsible management, safety officer or owner as set by the employer's electrical safety program.
No. NFPA 70E only accepts greater hazard or infeasibility as justification. Inconvenience or production loss alone does not qualify.
It is a state in which conductors have been disconnected, locked and tagged out, tested for absence of voltage and grounded where needed, so there is no shock or arc flash hazard.
Permits are usually written for a specific task and time period, often a single shift or job. If conditions, scope or crew change, the permit should be reviewed and reissued.
Part of SafetyIQ's EHS glossary: plain-English definitions of workplace health and safety terms.
> Keep learning
> See it in action
Capture hazards, run inspections, track training and close out corrective actions in one platform built for high-risk, field-heavy work.
Book my free demo